Error compiling for board Arduino/Genuino Mega or Mega 2560.

Having a problem? Post it here and someone will be along shortly to help
Post Reply
Slibhin
Noob
Posts: 1
Joined: Tue Mar 19, 2019 6:10 pm

Error compiling for board Arduino/Genuino Mega or Mega 2560.

Post by Slibhin »

Hi Everyone:

After not printing for almost a year, I found I can no longer connect to my Rostock Max V2 through MatterControl since Arduino was deleted from my Mac, so I decided to start from scratch and upload the latest firmware to my printer. Everything seemed to be fine clearing the Eeprom and changing configurations in the firmware to match the V2, until I try to upload the firmware to the printer when I get an error message that reads "Error compiling for board Arduino/Genuino Mega or Mega 2560." My display is now blank with 2 rows of blocks. Has anyone else experience anything like this? I'd hate to think my V2 is dead in the water.
Mac The Knife
ULTIMATE 3D JEDI
Posts: 1392
Joined: Sun May 11, 2014 6:18 pm

Re: Error compiling for board Arduino/Genuino Mega or Mega 2560.

Post by Mac The Knife »

Did you use Arduino IDE 1.6.0? Anything newer then that won't work,,,,, https://seemecnc.dozuki.com/Guide/RAMBo ... 50?lang=en
R-Max V2
Eris
Folger Tech FT-5 R2
Post Reply

Return to “Troubleshooting”