Stepper Config for V2 Rambo to Duet Wifi 1.04

Having a problem? Post it here and someone will be along shortly to help
Post Reply
CaduTwo
Plasticator
Posts: 6
Joined: Sat Sep 12, 2020 10:07 pm

Stepper Config for V2 Rambo to Duet Wifi 1.04

Post by CaduTwo »

Hi. I'm converting a V2 to a Duet 2 Wifi 1.04. The Red/Green and Blue/Yellow stepper pairs were flipped on the prev. Rambo setup.


Rambo GR BY
Duet RG YB

Should I be rewiring the Duet connector to match the Rambo or is that something that the prev. owner fixed in firmware and I should change the Duet config file?

TYVM
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Stepper Config for V2 Rambo to Duet Wifi 1.04

Post by geneb »

It would probably be easier for you to just flip the direction in the configuration.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
CaduTwo
Plasticator
Posts: 6
Joined: Sat Sep 12, 2020 10:07 pm

Re: Stepper Config for V2 Rambo to Duet Wifi 1.04

Post by CaduTwo »

TY. The motors worked as it was previously wired. One axis required direction flipping in the config. Steve from smcnc mentioned that they would only need to be rewired if they stuttered instead of moving. On to the next step of figuring out why the SE300 Z probe is triggered at rest state and only deactivating when the Z-axis is moving up.
Post Reply

Return to “Troubleshooting”