Maleficent Horns - (First Section) on my Rostock

[HesDeadJim]

Making a set of "Maleficent" horns for a Halloween costume. The entire project is comprised of six sections, this is a video of the first section. Using black ABS. (sorry for the wiggle...I should have centered more on the piece...I'm learning...)

[youtube]http://www.youtube.com/watch?v=H5UtwuQ4k6k[/youtube]

Here's the external link for those who can't view it on the forum:

https://www.youtube.com/watch?v=H5UtwuQ4k6k" onclick="window.open(this.href);return false;

[teoman]

whoow you have nice bed adhesion.

Will you be willing to share the stl's and settings?

[HesDeadJim]

The files are all on Thingiverse. Here's the link: http://www.thingiverse.com/thing:453002" onclick="window.open(this.href);return false;

The skullcap pieces (the largest pieces) are best printed upside down, so flip them 90 degrees from how they load so the "horn" is flat on the bed. This saves a TON of filament (not so much support generated) and a LOT of time (like, a whole day...)

Enjoy!

[HesDeadJim]

I'll grab my settings when I get home and post them. Anything in particular you might need?

[teoman]

Speeds temps support settings...

Those are pretty big prints and with my luck they will picass at 99%.

[HesDeadJim]

I took screenshots of the settings I used for the Maleficent prints and will post them below. I use ABS juice for the bed adhesion.

[Hydrolove]

Thanks for the setting. Seeing the part and the setting that go with it is a good idea. Maybe we could come up with a standard way to post that.

Kris