ABS very large print--not bad...

[GPriv]

I have a Rostock MAX v2 with "ghetto cover".

ghetto cover.jpg (24.52 KiB) Viewed 2247 times

and the cooling fan for the internals (see above picture--note how the internals are inside the table. Opposite side of fan there is no barrier--air free flows out):

fan 1.jpg (22.92 KiB) Viewed 2247 times

And I am using MatterControl:

nozzle dia. .5mm

extruder temp: 233
bed temp: 85

Please ask for more info in wanted.
Any suggestions would be greatly appreciated.

note: the mouse ears on the "box" (as original print) are 35mm diameter and 1mm thick). I had NO problems with lift during print using Elmer's Washable School Glue--disappearing purple. Great stuff.

BIG THANX!