Imperial paperweight

[barry99705]

Started out with this.
https://goo.gl/photos/zAM5Xqf5u7cmQTbv6

Then superglued it to a round piece of plywood that was screwed down to my mpcnc.
https://goo.gl/photos/4DkhCawwRngXY5Nv8

Faced the top with a 1/8" 2 flute end mill.
https://goo.gl/photos/KpAR2qgBr31eACU4A

Then milled out the rest with a 1/16" 2 flute end mill.
https://goo.gl/photos/gN68xyraLx6rxYJj7
https://goo.gl/photos/WTjPFeL3JoX8xsfn7
https://goo.gl/photos/6FPFxqjJBAzdYAFJ9
https://www.youtube.com/watch?v=1M1qZGLAEaQ

[geneb]

That's entirely too cool.

g.

[Glacian22]

Seconds Gene! Super cool!

[barry99705]

I'm actually really surprised at how well it went. I thought for sure the super glue would let go sometime within 5 minutes of finishing! I think next time I try it I'll use a quarter inch end mill to face it off though. Took forever with the eighth inch.