Hi everyone,
This is our first part, after a calibration cube. Very impressed for a 0.4 mm layer with 0.5 mm nozzle. We will try our 1 mm nozzle next time to do it with 0.8 mm layer.
Special thanks to Michael Hackney and his blog. Great tips !!!
Regards,
15 inch high Part
15 inch high Part
Benoit Despatis, P.Eng.
Chief Engineer at Sanuvox
Chief Engineer at Sanuvox
- Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: 15 inch high Part
That's pretty ambitious. Nice job!