Tool Caddy | 12v Power Center

Show off your latest creations, whether 3D printed or not
Post Reply
wepollock
Printmaster!
Posts: 180
Joined: Wed Apr 19, 2017 7:18 pm

Tool Caddy | 12v Power Center

Post by wepollock »

User avatar
Jimustanguitar
ULTIMATE 3D JEDI
Posts: 2631
Joined: Sun Mar 31, 2013 1:35 am
Location: Notre Dame area
Contact:

Re: Tool Caddy | 12v Power Center

Post by Jimustanguitar »

I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!
User avatar
PartDaddy
Printmaster!
Posts: 374
Joined: Fri Mar 23, 2012 4:03 pm

Re: Tool Caddy | 12v Power Center

Post by PartDaddy »

Cool
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996
User avatar
626Pilot
ULTIMATE 3D JEDI
Posts: 1720
Joined: Tue May 14, 2013 12:52 pm

Re: Tool Caddy | 12v Power Center

Post by 626Pilot »

I like the 12V box.
wepollock
Printmaster!
Posts: 180
Joined: Wed Apr 19, 2017 7:18 pm

Re: Tool Caddy | 12v Power Center

Post by wepollock »

Jimustanguitar wrote:I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!
Yep, zombie lights, that is for turning the dead on or off.. I was going to wire up a 12v distribution panel but it was much more efficient to purchase one intact.

https://www.ebay.com/itm/12V-6-Gang-LED ... 2749.l2649

My next step is to get rid of wall warts using buck converters or lm chips.
Post Reply

Return to “What are YOU making?”