Welcome to the SeeMeCNC Community

Posted: **Thu Jan 18, 2018 10:00 pm**

[img]https://i.imgur.com/XozuzDc.jpg[/img]

[img]http://i.imgur.com/vfJbThy.jpg[/img]

Posted: **Fri Jan 19, 2018 8:19 am**

I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!

Posted: **Sun Jan 21, 2018 8:11 am**

Posted: **Fri Jan 26, 2018 7:39 pm**

I like the 12V box.

Posted: **Thu Feb 01, 2018 4:34 pm**

Jimustanguitar wrote:I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!

Yep, zombie lights, that is for turning the dead on or off.. I was going to wire up a 12v distribution panel but it was much more efficient to purchase one intact.

https://www.ebay.com/itm/12V-6-Gang-LED ... 2749.l2649

My next step is to get rid of wall warts using buck converters or lm chips.

Welcome to the SeeMeCNC Community

Tool Caddy | 12v Power Center

Tool Caddy | 12v Power Center

Re: Tool Caddy | 12v Power Center

Re: Tool Caddy | 12v Power Center

Re: Tool Caddy | 12v Power Center

Re: Tool Caddy | 12v Power Center