Page 1 of 1

Tool Caddy | 12v Power Center

Posted: Thu Jan 18, 2018 10:00 pm
by wepollock

Re: Tool Caddy | 12v Power Center

Posted: Fri Jan 19, 2018 8:19 am
by Jimustanguitar
I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!

Re: Tool Caddy | 12v Power Center

Posted: Sun Jan 21, 2018 8:11 am
by PartDaddy
Cool

Re: Tool Caddy | 12v Power Center

Posted: Fri Jan 26, 2018 7:39 pm
by 626Pilot
I like the 12V box.

Re: Tool Caddy | 12v Power Center

Posted: Thu Feb 01, 2018 4:34 pm
by wepollock
Jimustanguitar wrote:I've seen that switch panel before... Says something about zombies, right?

Nice looking prints!
Yep, zombie lights, that is for turning the dead on or off.. I was going to wire up a 12v distribution panel but it was much more efficient to purchase one intact.

https://www.ebay.com/itm/12V-6-Gang-LED ... 2749.l2649

My next step is to get rid of wall warts using buck converters or lm chips.