Still need to revise a latch mechanism, but right now it's already a good press-fit for the lid that will serve it's purpose well.
Proto-X case
Proto-X case
Made a case for my Proto-X quadcopter:
Found a case on Thingiverse, but I didn't quite like it so I decided to make my own in OpenSCAD.
Still need to revise a latch mechanism, but right now it's already a good press-fit for the lid that will serve it's purpose well.
Found a case on Thingiverse, but I didn't quite like it so I decided to make my own in OpenSCAD.
Still need to revise a latch mechanism, but right now it's already a good press-fit for the lid that will serve it's purpose well.
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Proto-X case
Good job on designing and printing that proto-x case.
The quad copter sits in there perfectly and offers good protection.
The quad copter sits in there perfectly and offers good protection.
Re: Proto-X case
Very nice rhis is a great idea. Need to make something similar for my daughters quad. Ahhh too manu squirrels and not enoigh time...