Page 1 of 1
Use H1.1 for milling
Posted: Fri Sep 07, 2012 8:25 pm
by Paul Kelley
I assume the H1.1 could be used for milling also. If so what other hardware and software could be used for this?
Re: Use H1.1 for milling
Posted: Sat Sep 08, 2012 11:27 am
by johnoly99
Well, you could get away with tiny cuts, go check out our youtube channel and see steve doing a monalisa portrait on acrylic
Re: Use H1.1 for milling
Posted: Sun Sep 09, 2012 4:20 pm
by darus67
How did that Mona Lisa turn out, anyway?
I was watching the stream live when it was running, but I don't recall seeing the finished run.