The 25 hour print finished late last night. Pretty good for a hobby level printer. Now I have the 25mm fan pointed at the hot end, and 40 mm fan duct installed. Which unit should be considered Fan 0 and Fan 1? Where do I need to be looking in the software to control Fan 1?krak wrote:I printed this out last week. The 40mm fan just came in. When the current print is finished I plan on installing this and the 25mm fan.
Oh and so far the fans seem to be pretty well balanced.
Edit: I started a new thread about fan questions to keep this thread a little cleaner.
http://forum.seemecnc.com/viewtopic.php?f=54&t=2485