New(ish) Cura Support option

Talk about Cura software here (http://wiki.ultimaker.com/Cura)
Post Reply
User avatar
Nylocke
ULTIMATE 3D JEDI
Posts: 1421
Joined: Sun Jun 23, 2013 1:43 pm
Location: Iowa

New(ish) Cura Support option

Post by Nylocke »

Don't know how many of you noticed (if any) but theres an extra option for support in the advanced options pane. Instead of the solid unbreakable Cura support that destroys your part when you remove it, they have added a new "Lines" option. I have had good success with this new option, it comes off almost as easy as S3D support. Give it a try if you haven't already!
User avatar
Captain Starfish
Printmaster!
Posts: 962
Joined: Tue Dec 10, 2013 5:24 am

Re: New(ish) Cura Support option

Post by Captain Starfish »

Yep, have been using it on the Creatbot at work. It's pretty damned good stuff!
Post Reply

Return to “Cura”