Thought I would take some pix for first post.
Special thanks to Gene for the instructions.
Here it is printing 5th ABS test cube. 1st 4 tweaking to get it to stick.
Rostock Max V1 finally printing
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Rostock Max V1 finally printing
Good job in getting it working.
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”
Re: Rostock Max V1 finally printing
This is too much fun. Do I really have to go to work tomorrow
Big turd on top of pyramid, extrude temp to hot ??
Big turd on top of pyramid, extrude temp to hot ??
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Rostock Max V1 finally printing
Most likely to hot for such a small area, is it PLA? Do you have your layer fan on?wavetech wrote:This is too much fun. Do I really have to go to work tomorrow
Big turd on top of pyramid, extrude temp to hot ??
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”
Re: Rostock Max V1 finally printing
ABS no fan, fan not working at moment have to setup/troubleshoot.
Re: Rostock Max V1 finally printing
That electronics compartment is one of the cleanest I've seen so far.
When you get to things like the top of the pyramid, it gets kind of soft because it doesn't give the area time to cool. What you've got there is pretty typical. Nice first prints though!
When you get to things like the top of the pyramid, it gets kind of soft because it doesn't give the area time to cool. What you've got there is pretty typical. Nice first prints though!
- Print_This
- Printmaster!
- Posts: 86
- Joined: Sun Feb 23, 2014 11:56 pm
Re: Rostock Max V1 finally printing
lol that is hilarious, i never thought i could stand and stair for 1 or even 2 hours just watching layers by layers, mmm do i have to go to work as well lol awesomewavetech wrote:This is too much fun. Do I really have to go to work tomorrow
Big turd on top of pyramid, extrude temp to hot ??
--------------
If you survive chicago winters you can survive 3d printing!
If you survive chicago winters you can survive 3d printing!