New Enclosure for my V3

Post a pic of your CNC machines!
Post Reply
jlvter
Prints-a-lot
Posts: 25
Joined: Sun Oct 16, 2016 8:41 pm

New Enclosure for my V3

Post by jlvter »

Printed the parts from this Thingiverse project:
https://www.thingiverse.com/thing:1796438

Used 6mm Luan subfloor for panels, 1 piece of Lexan for window in door. Total of about $40 including a can of white paint. Used garage door foam sealing tape around door. Aluminum duct tape on all interior panel seams. Maintains about 98 degrees F inside when printing ABS. Measured about 1" above print bed. Printer is in shop that is kept around 65 degrees.

https://www.thingiverse.com/make:405336
Post Reply

Return to “Show us your machine!”