Upgraded V2 automagic calibration question.

[barry99705]

Hey guys, I have one of those fancy pants boards on the hot end so it does the tappity-tap-tap auto calibration. When it's doing this, shouldn't the effector platform stay parallel to the bed?

[geneb]

Which one do you have, the HE280 or the SE300? (what controller is in the printer?)

The effector should always be parallel with the build plate.

g.

[barry99705]

The HE280. Controller is the standard Rambo, not sure which version. Now that I've watched it a few times, I think it's the flying extruder I added. Pulling too much on the hot end.

[barry99705]

Nope, that wasn't it. Now when I hit calibrate, the board resets. Any ideas? Firmware is 92.2

[barry99705]

Holy crap. SD card corrupted. Put a new on in, and it was formatted fat32, didn't realize that. Reformatted fat, calibration runs now. Effector platform still not running level at the tap points though.
[img]https://lh3.googleusercontent.com/BhXTL ... 24-h768-no[/img]

[geneb]

The image doesn't show up.

g.