22ga wires too short?

Discussions related to the Rostock MAX v2
Post Reply
Kenshh
Noob
Posts: 2
Joined: Wed Jun 04, 2014 2:33 pm

22ga wires too short?

Post by Kenshh »

So I'm almost done with the assembly side of the build but the one problem i've come across is that the wires that connect to the print head are too short.
Even when only an inch of wire is left at the bottom of the aluminum post, the furthest down i can get the wire to reach is about half way.
Surely that isnt enough since that would mean that the head wouldn't be able to reach the printer's base plate?

Any help or advice on this would be a huge help!

geneb
ULTIMATE 3D JEDI
Posts: 5143
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: 22ga wires too short?

Post by geneb »

Ken, you need to contact [email protected]

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

Kenshh
Noob
Posts: 2
Joined: Wed Jun 04, 2014 2:33 pm

Re: 22ga wires too short?

Post by Kenshh »

Oh okay
Thanks

richardphat
Prints-a-lot
Posts: 25
Joined: Thu Jun 05, 2014 10:43 pm

Re: 22ga wires too short?

Post by richardphat »

The wire should measure about 10 feets, however, I only received 4 feets 1/2. I went to some shop and bought 4-22 gauge. Since I need it asap, I went to the shop and grab some extra wires.

Post Reply

Return to “Rostock MAX v2”