22ga wires too short?
Posted: Tue Jun 17, 2014 8:40 am
So I'm almost done with the assembly side of the build but the one problem i've come across is that the wires that connect to the print head are too short.
Even when only an inch of wire is left at the bottom of the aluminum post, the furthest down i can get the wire to reach is about half way.
Surely that isnt enough since that would mean that the head wouldn't be able to reach the printer's base plate?
Any help or advice on this would be a huge help!
Even when only an inch of wire is left at the bottom of the aluminum post, the furthest down i can get the wire to reach is about half way.
Surely that isnt enough since that would mean that the head wouldn't be able to reach the printer's base plate?
Any help or advice on this would be a huge help!