Quick question...
I haven't touched my printer in many months due to moving around and stuff. I figured I would start fresh because I don't remember much.
Before I was using repetier host and now I installed MatterControl.
So far it's working great but I'm not sure about the bed size. It says 150 x 150 but that is only about half my bed size. Is this measured by the radius? or is there a giant safety buffer around my print area?
I was trying to print the fancy articulated octopus and stick as many tentacle pieces on there as a I can but I don't want to waste a print by trying to print off of the bed.
Thanks!
Circular Bed Size
Re: Circular Bed Size
In Repetier and MatterControl there is a place you can specify that you have a round bed.
The radius of your bed is 11" or 280mm in metric. I hope that helps!
The radius of your bed is 11" or 280mm in metric. I hope that helps!
Rostock MAX V2 with trick trucks, cf arms, prometheus hot end, nimble extruder, berdAir cooling.
Cura slicer, Duet Wifi, iMac
Cura slicer, Duet Wifi, iMac