Tough Ink by M3D
Tough Ink by M3D
Anybody tried this stuff out yet? http://printm3d.com/3d-printer-filaments/tough-3d-ink
Re: Tough Ink by M3D
I bought a small spool of this and tried it on my Orion today. I am getting pretty good results printing at 215C and 15mm/s. It is very flexy and strong. I was suprised the stock extruder/Bowden setup on the Orion could handle it. Thus far, I have only done continuous spiral mode prints with no travels and no infill.
M3D doesn't give you very much info on this material.
M3D doesn't give you very much info on this material.
Re: Tough Ink by M3D
I bought some SemiFlex also, and it seems to have about the same flexibility as the Tough Ink, which explains why the Tough Ink seems to print OK in the Orion.
Re: Tough Ink by M3D
I am getting the best results with the Tough Ink at 205C and 15mm/s. I tried 25mm/s, but the filament got looped inside the stock Orion extruder and stopped feeding.
Even hollow objects with a single perimeter wall are really tear-resistant, with great layer adhesion.
Even hollow objects with a single perimeter wall are really tear-resistant, with great layer adhesion.