Help with Power Supply Wire Cutting

Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
Post Reply
brdsheen
Noob
Posts: 4
Joined: Sat Jan 23, 2016 11:55 am

Help with Power Supply Wire Cutting

Post by brdsheen »

SO.... I bought the Droplit Kit from MatterHacks and am up to the part on the power supply where you cut two black and two yellow wires. These wires are connected onto the position terminal block along the edge of the gShield. The black wires go into the position marked “GND” and the yellow wires go into the position marked “Vmot”. But the power supply that came with my kit was from diablotek, and am having trouble finding these wires. If you can identify them in the pictures marked below I would be very grateful. THANKS YALLS. :D :D :D :D :D :D :D :D :D

All pictures are in the imgur link below:

http://imgur.com/gallery/1v0g3/new" onclick="window.open(this.href);return false;
bubbasnow
ULTIMATE 3D JEDI
Posts: 1064
Joined: Fri Aug 02, 2013 4:24 pm
Location: Dayton, WA

Re: Help with Power Supply Wire Cutting

Post by bubbasnow »

yellow is 12v, red is 5v, orange is 3.3v all in DC. if you only need 2 yellow/black i would cut them from 4 in your first picture, and leave the remaining wires safely insulated in the connector.
brdsheen
Noob
Posts: 4
Joined: Sat Jan 23, 2016 11:55 am

Re: Help with Power Supply Wire Cutting

Post by brdsheen »

Thanks!
Post Reply

Return to “DropLit”