Connector fell off. Pictures or wiring diagram for the RAMBo?

The ERIS Delta, a truly affordable entry into Delta 3D Printing
Post Reply
User avatar
626Pilot
ULTIMATE 3D JEDI
Posts: 1720
Joined: Tue May 14, 2013 12:52 pm

Connector fell off. Pictures or wiring diagram for the RAMBo?

Post by 626Pilot »

I was replacing the stock motors per Jetguy's suggestion, when I noticed that a connector with only one blue wire had come loose:
Eris connector.jpg
The pin header it seems to go to is five pins wide, and the connector is four pins wide. It can be attached facing either direction. This means that there are four different ways it can be connected, only one of which is correct. How does it plug in?
guanu
SeeMeCNC Staff
Posts: 397
Joined: Mon Mar 26, 2012 1:54 pm

Re: Connector fell off. Pictures or wiring diagram for the RAMBo?

Post by guanu »

It goes right behind that plug with the thin red and black wires... the wire connects to the second pin from the edge of the board, so you will line the plug up with the top pin (the plug with the red and black and offset by one pin, this way the two plugs can butt up against each other)
Eric
Printmaster!
Posts: 726
Joined: Sat Aug 18, 2012 4:09 am
Location: Chula Vista, CA

Re: Connector fell off. Pictures or wiring diagram for the RAMBo?

Post by Eric »

I'm a little surprised SeeMe used two 4-pin connectors instead of a single 10-pin connector for a 10-pin header.
Post Reply

Return to “ERIS Delta”