Awesome, thanks! It looks like you have a heated chamber, so I commented that out. I'll give it a try. I'm curious about the motor currents and accelerations after digging through the configurator. I started looking through the default repetier configuration.h file and found the currents set to 140 for the tower motors and 130 for the extruder, I assume that means 1400 mA and 1300 mA respectively? Should that make any difference from the default 1000mA in your config?
I assume a lower acceleration is good, but repetier also has
#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 1850
#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 1850
#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Z 1850
#define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_X 3000
#define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Y 3000
#define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Z 3000
#define MAX_JERK 32
#define MAX_ZJERK 32
I don't know if the DC42 firmware values are "max" or just a target acceleration value. from the config.g:
M201 X1000 Y1000 Z1000 E1000 ; Accelerations (mm/s^2)
Those are a couple of the things i was having a hard time wrapping my cranium around
![Smile :)](./images/smilies/icon_e_smile.gif)
. thanks again!