[img]https://i.imgur.com/XozuzDc.jpg[/img]
[img]http://i.imgur.com/vfJbThy.jpg[/img]
Tool Caddy | 12v Power Center
-
Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2608
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: Tool Caddy | 12v Power Center
I've seen that switch panel before... Says something about zombies, right?
Nice looking prints!
Nice looking prints!
Re: Tool Caddy | 12v Power Center
Cool
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996
Re: Tool Caddy | 12v Power Center
I like the 12V box.
Questions? Ask in a thread - PMs are off.
AI Calibration | Dimensional Accuracy Calibration | Hand-Tune your PID | OctoPi + Touchscreen setup | My E3D hot end mount, Z probe, fan ducts, LED ring mount, filament spool holder, etc.
AI Calibration | Dimensional Accuracy Calibration | Hand-Tune your PID | OctoPi + Touchscreen setup | My E3D hot end mount, Z probe, fan ducts, LED ring mount, filament spool holder, etc.
Re: Tool Caddy | 12v Power Center
Yep, zombie lights, that is for turning the dead on or off.. I was going to wire up a 12v distribution panel but it was much more efficient to purchase one intact.Jimustanguitar wrote:I've seen that switch panel before... Says something about zombies, right?
Nice looking prints!
https://www.ebay.com/itm/12V-6-Gang-LED ... 2749.l2649
My next step is to get rid of wall warts using buck converters or lm chips.