NEMA 17 Stepper Motor settings for arduino?

[spart]

NEMA 17 Stepper Motor problem, finely got a framewire to go to rambo board setttings all mest up but it worked. but when i turn on power i can here one stepper making a grunting noise might have something set wrong in arduino, not to sure what number to use to get to currant 1.8
anyone have this problem or no what going on

[Capt Jack]

Grunting?
Possible that only 1 of the coils is running. My motors were skipping like crazy and I foudn out that 1 of the wires on the board wasn't making contact, so the motors were only getting half powered. Make sure that you have eveything wired solid. You can check the resistance of each of the two pairs of wires. If they don't match, then one of them isn't connected properly.

[spart]

got it all running now other then hot bed and hot end cant figure out the settings for thermostat and resisters

almost don't count after today got my usb cord stuck in my chair wheel and ripped off usb adapter of rambo board what a bad day

thank god i had some old printer parts i striped down and soder new one back on dam lucky i was just about to cryyyyyy cost me 200 bucks for shiping and exchange alown

[astroboy907]

got it all running now other then hot bed and hot end cant figure out the settings for thermostat and resisters

almost don't count after today got my usb cord stuck in my chair wheel and ripped off usb adapter of rambo board what a bad day

thank god i had some old printer parts i striped down and soder new one back on dam lucky i was just about to cryyyyyy cost me 200 bucks for shiping and exchange alown

God's gift to Man: Old electronics and soldering irons.

[lordbinky]

Psh, why so delicate? Take a heat gun and just shake all the parts out .