A video on finding the perfect filament temp

[McSlappy]

https://www.youtube.com/watch?v=POaL2GGBHGM

It's a short one but hopefully is helpful in tuning the myriad of filaments / brands you've got laying around.

Cheers.

[teoman]

Thank you again for the awesome video.

I had watched another one on youtube, where the GCode is modified a bit to decrease the temperature in steps. And in the end you end up with a shape that you can observe the temperature differences on a single object.

[bot]

Along these same lines, there is a plugin for Cura that varies the print temperature based on the actual print speed (because Cura slows it down sometimes).

http://wiki.ultimaker.com/CuraPlugin:_Flowthermostat

Using this video to find the max and min temperatures to vary between would lead to really great results.

[Eaglezsoar]

Along these same lines, there is a plugin for Cura that varies the print temperature based on the actual print speed (because Cura slows it down sometimes).

http://wiki.ultimaker.com/CuraPlugin:_Flowthermostat

Using this video to find the max and min temperatures to vary between would lead to really great results.

Thanks for the info on this plugin. I did not know it even existed.