LED blinking

[GPriv]

I've looked throughout the manual and cannot find anything on the LEDs--the green and the yellow.

(My) green is on, and yellow is blinking. Is this normal?

My 'puter still cannot communicate with printer. Com3 is getting ACCESS DENIED window. I cannot figure out how to get it all working. Instructions has no advice on the matter.

ANY info would be GREATLY appreciated.

Thanx in advance.

-Greg

[Tincho85]

Did you install the Rambo driver?
If so, does windows recognizes your printer? Check under Pc Settings / devices

[GPriv]

I finally rolled back the 'puter to a much earlier date--soon after I had gotten everything up and running (a year ago). Of course, the printer is now communicating with 'puter.
I investigated the driver and (see pic) this is the details. I believe the previous (before rolling 'puter back) was NOT this. I do not remember what it was, but I do not recall this.

driver details.jpg (30.59 KiB) Viewed 3854 times

Unfortunately< i must put the 'puter back to the up-to-date settings as I have lost a bunch of files. Freakin' WindBlows. UGH!!