Page 2 of 2
Re: Frustrating set up process
Posted: Mon Jul 22, 2013 12:41 pm
by Eaglezsoar
tc3jg wrote:Thank you eaglezsoar. Are there instructions for the ez extruder that's exactly what it is and since I have a 2pound spool that's probably the best way for me to mount it
I don't see instructions as such and I did check youtube.
There are pictures at the link I gave you, hopefully you can figure it out from the pictures.
I wish I could be more help but I could not find any instructions.
Re: Frustrating set up process
Posted: Mon Jul 22, 2013 2:21 pm
by Broose
tc3jg wrote:Thank you eaglezsoar. Are there instructions for the ez extruder that's exactly what it is and since I have a 2pound spool that's probably the best way for me to mount it
There are instructions and photos in the latest "Rostock Max Assembly Manual" that Geneb has written (pp 87-96 on Version 2 of the guide or search for ezstruder)
http://download.seemecnc.com
Edit: the version number on the first page is 1.09 - July 10, 2013
Re: Frustrating set up process
Posted: Tue Jul 23, 2013 12:38 am
by tc3jg
Ok broose that's the guide I have I wonder how I missed it.
Edit there's no info on how to put together the top mounted ez extruder just the lower one
Re: Frustrating set up process
Posted: Tue Jul 23, 2013 11:27 am
by geneb
What's the version number on the first page of the manual?
g.
Re: Frustrating set up process
Posted: Thu Jul 25, 2013 12:31 am
by tc3jg
geneb wrote:What's the version number on the first page of the manual?
g.
[img]
http://i292.photobucket.com/albums/mm22 ... 7d2409.jpg[/img]
Re: Frustrating set up process
Posted: Thu Jul 25, 2013 7:47 am
by Broose
Mine is V 1.09 - July 10, 2013 and it has instructions and photos for the EZStruder overhead mount. I guess you'll have to download it again.
http://download.seemecnc.com
Re: Frustrating set up process
Posted: Thu Jul 25, 2013 9:19 am
by geneb
SeeMeCNC hasn't caught up yet.
The latest rev is 1.10 dated July 18th. I post an update in the official docs thread each time I post an update to the manual. It's a constantly evolving document as I receive feedback and errata from the community.
g.
Re: Frustrating set up process
Posted: Thu Jul 25, 2013 12:19 pm
by tc3jg
geneb wrote:SeeMeCNC hasn't caught up yet.
The latest rev is 1.10 dated July 18th. I post an update in the official docs thread each time I post an update to the manual. It's a constantly evolving document as I receive feedback and errata from the community.
g.
NO worries Gene Im downloading it now. I m sure I will find some more info that can help me Thanks for all you do
Broose thanks for your consistent help too.
Fellas keep an eye on this thread im trying to get some good prints!
