Page 2 of 2
Re: I need a Printer Whisperer... I think I'm the underdog.
Posted: Tue Sep 10, 2013 12:35 pm
by lordbinky
I had .05 mm prints working well for a couple days, (yes it has rained since then... lol), the biggest issue I had at the time was the bed warp was noticeable at that degree...for the first layer..Oops I guess my perfectionist is showing there. Ok ok.. point taken Gene.
Re: I need a Printer Whisperer... I think I'm the underdog.
Posted: Wed Sep 11, 2013 10:03 am
by geneb
There's firmware coming that will compensate for things like this - as long as the glass is nearly perfect, you're golden.
g
Re: I need a Printer Whisperer... I think I'm the underdog.
Posted: Wed Sep 11, 2013 11:54 am
by Eaglezsoar
geneb wrote:There's firmware coming that will compensate for things like this - as long as the glass is nearly perfect, you're golden.
g
I keep hearing about the new firmware, do you or anyone reading this know of an estimate of how long before we see the auto-calibration
of the bed? Seems like there were 2 or 3 people working on it plus SeeMeCNC and now no one is mentioning it. Sorry but I am anxious
to incorporate this into my Rostock Max.
Re: I need a Printer Whisperer... I think I'm the underdog.
Posted: Wed Sep 11, 2013 1:24 pm
by geneb
Patience, grasshopper!
g.
Re: I need a Printer Whisperer... I think I'm the underdog.
Posted: Wed Sep 11, 2013 2:11 pm
by Eaglezsoar
geneb wrote:Patience, grasshopper!
g.
More like a locust!
