Page 1 of 1
ABS juice for PETg bed adhesion
Posted: Mon Apr 04, 2016 6:07 pm
by gestalt73
I was having bed adhesion issues with a recent large-ish PETg print with my PVA gluestick, so tried gluestick + ABS juice out of desperation.
Turns out it works really well.
I still haven't tried my PEI sheet, so don't know how it works with PETg.
Re: ABS juice for PETg bed adhesion
Posted: Mon Apr 04, 2016 7:54 pm
by JFettig
Pei will grip too hard. Very difficult to remove. PVA as taulman prescribed is the best. Glue all and water mix
Re: ABS juice for PETg bed adhesion
Posted: Mon Apr 04, 2016 8:32 pm
by ccavanaugh
I use PEI and PETG without too much issue. Don't squish the first layer. Bed and 70 -75C for small parts and 80C for larger parts. Pop the plate in the freezer and they release fairly easily.
Re: ABS juice for PETg bed adhesion
Posted: Tue Apr 05, 2016 6:16 am
by Glacian22
I print a lot of PETG, and hairspray does the trick for me.