Welcome to the SeeMeCNC Community

Posted: **Thu May 19, 2016 1:10 pm**

I have a probleb with rambo ver 1.2

When i turned the board on (Pluged the powers) green led lits up after that all the red lights lit up without any control.

Posted: **Thu May 19, 2016 1:31 pm**

You should try to load the repetier software, then check the LED behavior. Maybe some other program is loaded that's turning stuff on.

Posted: **Sat Apr 22, 2017 12:47 pm**

Have you fix the problem? How exactly did you get rid off the RED LED on Rambo board?

Welcome to the SeeMeCNC Community

turned it on all the red lights lit up

turned it on all the red lights lit up

Re: turned it on all the red lights lit up

Re: turned it on all the red lights lit up