filament stuck in HE280 hotend -RostockMax v3
Posted: Mon Oct 10, 2016 5:41 pm
found today first failure after build:)
filament stuck in HE280
step 28 final assembly
The Bowden tube will fit nearly the entire length of the hot end, so make sure it's fully seated.
when i did it hangs at 20mm
and should go deeper 43mm in HE280.
filament stuck in HE280
step 28 final assembly
The Bowden tube will fit nearly the entire length of the hot end, so make sure it's fully seated.
when i did it hangs at 20mm
and should go deeper 43mm in HE280.