Page 1 of 1

Filament Stuck in Heatsink - Help!! :)

Posted: Fri Jan 06, 2017 11:59 pm
by Ravitch
Well now I've went and done something new. My first Bowden setup and here I went and done a stupid and tried to unload some PLA while the hot end was only 180, and the PLA broke and is now stuck halfway in the middle of the heat sink thingy.

How in the world do I get that out? I've cleared jam nozzles before but this is a whole new beast. Thanks!!

Re: Filament Stuck in Heatsink - Help!! :)

Posted: Sat Jan 07, 2017 2:37 am
by Ravitch
Problem solved, nothing a complete disassembly couldn't fix :)

On to the next self-imposed crisis!