Welcome to the SeeMeCNC Community

Hi,

I just got time to start building my kit, and I've gotten to the "jump to pt 17 and install the idler bearings" part. Problem is, I can't tell how to install them.
in the picture it looks as though the bearings are installed on the motor mount and tri-support? One and then the other in a straight line.

The holes in my motor mount-tri-support don't seem to match. There aren't any in a straight line. Are there any other pictures available? Maybe one from the top (without the top plate attached)? Thanks.

-sandy

the bearings are not lined up with each other they are slightly off, back one is higher than the other. this what u meant?

that does help. I was afraid that I'd put the supports together wrong. Thanks.

I know cambo3d already helped but here is another shot from an acrylic rostock so you can see it from the side.

[img]http://i1299.photobucket.com/albums/ag6 ... e00bad.jpg[/img]

thanks for the pic. That is how mine looks. And, it also helps me see how the belts should go. I'll be doing those this weekend.

best,

-sandy