Welcome to the SeeMeCNC Community

so I finally got the firmware downloaded. well I am such a noob I for the life of me cannot seem to get this stupid arduino stuff figured out.... so anyone have a simple do this , then this, then this, kind of instructions.... i watched a few vids way in over my head. gonna blow things up for sure. currently the LCD displays ver .83 sooooo cloooose

Tom C

http://youtu.be/gLwpEPalXUo found this from here http://forum.seemecnc.com/viewtopic.php ... are#p27347. It is for the orion but it does a good job of showing what to do to upgrade firmware on a repetier board.