Welcome to the SeeMeCNC Community

Posted: **Tue Apr 29, 2014 2:36 pm**

Hello...

I've printed the fan shrouds in ABS, and would like to change to PLA for future prints. What settings need to be changed? Temps need to change, but I'm not sure what else. I know there is a PLA settings file for Slic3r, but what about in Cura?

Thanks

-David

Posted: **Tue Apr 29, 2014 2:38 pm**

besides the temps, you will want to run the layer fan if you have it installed.. besides that, nope.. just temps and fan are the only changes for pla that I really do

Guanu

Posted: **Tue Apr 29, 2014 3:11 pm**

cool, thanks

-David

Welcome to the SeeMeCNC Community

settings to change ABS to PLA

settings to change ABS to PLA

Re: settings to change ABS to PLA

Re: settings to change ABS to PLA