Page 1 of 1
New EVGA power supply wiring question
Posted: Sat Dec 13, 2014 5:00 pm
by jram
Hello All,
I just bought an EVGA supernova NEX650G to power my Max v2, the included diablotek crapped out during calibration. Support is great, they are sending a new Viotek but I'll use that one as a backup. I'm wondering how I go about wiring this?(I'm a noobie when it comes to wiring and I want to be sure to not fry the machine! I have attached a few images, the wires are all black and there are no other colors so I'm a bit confused. Also, do I still bundle 4 together like I did with the Diablotek?(once I find out which 4 to bundle
Re: New EVGA power supply wiring question
Posted: Sat Dec 13, 2014 5:33 pm
by Mac The Knife
If you have the connector you cut from the other psu, you could use it as a guide. The wires may be all black on the new one, but the pin positions are the same.
Re: New EVGA power supply wiring question
Posted: Sat Dec 13, 2014 6:29 pm
by Kevinvandeusen
Here you go!
Re: New EVGA power supply wiring question
Posted: Sat Dec 13, 2014 7:22 pm
by jram
Kevinvandeusen wrote:Here you go!
Thank you!!
Re: New EVGA power supply wiring question
Posted: Sun Dec 14, 2014 3:55 pm
by add1ct3dd
You will need to make sure you use multiple 12v lines.
Re: New EVGA power supply wiring question
Posted: Sun Dec 14, 2014 4:10 pm
by jram
Thanks guys, I wired it up last night and now the bed and hot end will actually reach target temp and stay there. Now I'm just working on an ezstruder issue.