I think I'm haunted... [solved]

[dcfc_sandy]

So last night two pictures fell of the walls in my room, thought nothing of it. Then this morning I turn on Rusty and the bed refuses to heat! Damn ghost been all up in my printer!!!!!

But I've checked the wiring to the RAMBo and the bed its all kosher, so I'm waiting for my house mate to wake as he has a multimeter and I'll test the fuse as well as voltage to the RAMBo and bed. Anything else it could be...?

The LED doesn't come on, nor does the bed heat

Everything else on the printer works.

[dcfc_sandy]

So I took out the 12V for the bed from the RAMBo tested each one and was getting between 8.9V and 11.8V ouch :/ but all worked fine, braided and out back in, and it worked...

So it was a lose wire... Even after taking out previously and braiding again, odd as the machine hadn't move since the last print. Stupid ghost!