Welcome to the SeeMeCNC Community

Got the new version of Slic3r and wanted to integrate it with MatterControl, put the files in the same local as the old version and it won't complete the slicing process. It errors out with "Slicing Error. Please review slicing settings"
I have reviewed all the slicing settings and there aren't any that are out of whack. If I run Slic3r outside of MatterControl with the same settings and model it slices just fine.


Any help would be appreciated.

You might want to contact the guys at MatterHackers directly. I suspect the integration is a bit more complex than just replacing the files.

g.