Circular Bed Size
Posted: Wed Jul 29, 2015 12:12 am
Quick question...
I haven't touched my printer in many months due to moving around and stuff. I figured I would start fresh because I don't remember much.
Before I was using repetier host and now I installed MatterControl.
So far it's working great but I'm not sure about the bed size. It says 150 x 150 but that is only about half my bed size. Is this measured by the radius? or is there a giant safety buffer around my print area?
I was trying to print the fancy articulated octopus and stick as many tentacle pieces on there as a I can but I don't want to waste a print by trying to print off of the bed.
Thanks!
I haven't touched my printer in many months due to moving around and stuff. I figured I would start fresh because I don't remember much.
Before I was using repetier host and now I installed MatterControl.
So far it's working great but I'm not sure about the bed size. It says 150 x 150 but that is only about half my bed size. Is this measured by the radius? or is there a giant safety buffer around my print area?
I was trying to print the fancy articulated octopus and stick as many tentacle pieces on there as a I can but I don't want to waste a print by trying to print off of the bed.
Thanks!