Welcome to the SeeMeCNC Community

The Viki Display is a handsome unit although expensive.
My problem is that once purchased, there are no instructions on how to connect it to ANY of the popular Controllers such as Ramps, Rambo, and many more.
Sending an email to Roy at Pannucatt is an exercise in futility.
Does anyone know how to connect this display to a controller and if so how is it done. If parts are needed please provide a link to what is needed.

The most expensive paperweight I ever bought. The formum has dribs and draps of info like I got the Viki to work, but that is not much help.

Your experience in customer support is what it is. But the info you seek is on their website, linked off the product pages:

viki v1:http://www.panucatt.com/product_p/vikilcd.htm, wiring diagram and schematic links at bottom.
viki v2:http://www.panucatt.com/product_p/vikilcd2.htm, support files link at bottom, then wiring diagram link. No schematic, but probably very similar to v1.

Eric wrote:Your experience in customer support is what it is. But the info you seek is on their website, linked off the product pages:

viki v1:http://www.panucatt.com/product_p/vikilcd.htm, wiring diagram and schematic links at bottom.
viki v2:http://www.panucatt.com/product_p/vikilcd2.htm, support files link at bottom, then wiring diagram link. No schematic, but probably very similar to v1.

Thank you Eric, I did find the needed info from the links you posted and they should help me connect the Viki.