The Rev5 Onyx bed has 2 LEDs, the manual shows one going to the Rambo.
Where does the other one plugin on the Rambo board?
Search found 4 matches
- Sat Jul 05, 2014 11:11 pm
- Forum: Rostock MAX v2
- Topic: Assembly manual discussion thread!
- Replies: 304
- Views: 231179
- Sat Jun 14, 2014 8:07 pm
- Forum: Rostock MAX v2
- Topic: Assembly manual discussion thread!
- Replies: 304
- Views: 231179
Re: Assembly manual discussion thread!
Also does the bed need to be counter sunk for the screws to be in stalled?
- Fri Jun 13, 2014 5:17 pm
- Forum: Rostock MAX v2
- Topic: Assembly manual discussion thread!
- Replies: 304
- Views: 231179
Re: Assembly manual discussion thread!
second resistor goes where its labeled "RES" just like for the heated bed LED.... the resistor goes from the RES pad to the + pad.. and then the + and - for hot end led go to the hotend wiring on the rambo for the hotend... (with the rambo green screw terminals at the top, the first 2 spo...
- Fri Jun 13, 2014 6:17 am
- Forum: Rostock MAX v2
- Topic: Assembly manual discussion thread!
- Replies: 304
- Views: 231179
Re: Assembly manual discussion thread!
I have a question about the Onyx Headed Bed, Rev3. in the Rostock MAX v2 Assembly Guide.
The kit came with 2 LEDs an 2 Resistors.
I installed the LEDs.
Where does the second Resistor go?
It’s not in the manual.
I also have a picture of the bed.
Can you help me?
Thanks,
Ron
The kit came with 2 LEDs an 2 Resistors.
I installed the LEDs.
Where does the second Resistor go?
It’s not in the manual.
I also have a picture of the bed.
Can you help me?
Thanks,
Ron