Hi Tom,
I have been using Slic3r but have today switched tio MatterControl. Am planninbg on trying a pointy print tonight with it.
Carl
Search found 7 matches
- Mon Jun 22, 2015 10:41 am
- Forum: ORION
- Topic: Small Layer issue with ABS print
- Replies: 4
- Views: 4285
- Mon Jun 22, 2015 7:14 am
- Forum: ORION
- Topic: Small Layer issue with ABS print
- Replies: 4
- Views: 4285
Re: Small Layer issue with ABS print
I have found the post on filament coolling settings - will this sort the problem?
Will try it but confirmation would be appreciated, I am still a nervious noobie
Will try it but confirmation would be appreciated, I am still a nervious noobie
- Mon Jun 22, 2015 4:14 am
- Forum: ORION
- Topic: Small Layer issue with ABS print
- Replies: 4
- Views: 4285
Small Layer issue with ABS print
Hi, I am relative new comer to 3d printing and I have a small issue I would like some advice on. I am printing in ABS, using Elmers glue stick, at 105 degrees bed temp and 230 degrees nozzle temp. THe geberal quality is great except when I have small layers. I am slicing using Repetier and Slic3r. M...
Re: WITS END
Just wanted to thank everyone who has posted on this thread. I too have been suffering with the first layer not adhering. Having read the thread I have now run a recalibration of my Z index and managed to easily move the nozzle 0.25mm closer to the bed. I have reset my bed temperature and my nozzle ...
- Wed Jun 18, 2014 8:07 pm
- Forum: New Member introduction
- Topic: Hello
- Replies: 5
- Views: 3733
Re: Hello
Hi McSlappy. I have been a Nao Developer, on their developer program, for the last 3 1/2 years. I also co-founded their UK user group and the user group has arrange 2 hackathons and this year we are arranging an international conference. I have been very lucky to be able to have my own Nao and recen...
- Wed Jun 18, 2014 8:06 pm
- Forum: New Member introduction
- Topic: Hello
- Replies: 5
- Views: 3733
Re: Hello
Hi Eagle, I am printing in PLA at present (ABS on order) and I was using glue witha bed temp of 70 degrees C. I think I have worked out my issue. I was too impatient. The last few prints I have done this evening I have left to cool on the bed and they are far easier to remove. Carl Hi Carl and welco...
- Wed Jun 18, 2014 6:26 pm
- Forum: New Member introduction
- Topic: Hello
- Replies: 5
- Views: 3733
Hello
Hi, My name is Carl and I have just taken delivery of an Orion Delta. Have just about got it all setup and have done a couple of test prints. Some have been successful and others not but I know a lot of this is due to my lack of experience. Currently, using the PLA that came with the printer but I h...