Welcome to the SeeMeCNC Community

Got fuse, installed fuse, printing now. =) So happy!

Tested and confirmed. It is the fuse.

I ordered 5. I also spent most of the day trying to find some place local that might have them. Nope, not one place I can find has these fuses local.

The day I got mine I was up till 4am working on it. Just one more part. Just one more page. I could not stop.

2 hours of sleep is not enough before you have to go to work.

So, we think its the F2 fuse. I have ordered some and hope thats it. I hate waiting.

The green light by the reset switch stays on. There is an amber one that blinks in the middle of the board. When I run the calibration for the hot end and heat bed there are 2 red lights that come on. Anyone know where to get a fuse? I was actually thinking the fuse might be blown and even went to R...

I have it all together, turns on fine. Loaded the software but when I go to set the Home position, no movement at all. Its like the motors are not getting any power. Any ideas?

I finished building my MAX v2. I am in the process of loading all the drivers and software which seemed to go as it should. When I get to the Initial Function Tests and the instructions tell you to set the home placement by hitting the home button in the Repetier software, nothing happens. Its like ...

I ended up getting a butane one from the hardware store. I know, its a cheap one but I have other things that it would be great for. Everything seems to be going good so far. I have the top section on and will be doing the wiring next. The only thing I had a question on was the heat bed. I received ...

Thank you Sir. Much appreciated. Im a total noob with this stuff. =)

so do I just not add the other resistor and the green and white wires?

Is there an update for Rev 7? The soldering points are different from Rev 6.

Worked on building for 5-6 hours last night. I got the bottom build and some of the top. Need to run to the store today and get a soldering iron to put the bed together, I cant seem to fine my old one.

Well I just picked this up from UPS today. Now I have to wait with it sitting in my car till I get off work and get home to start working on it. Its going to be a long day.

I have ordered mine and am currently waiting delivery. Any updates on problems or success's would be greatly appreciated.

I ordered mine yesterday but it has not shipped yet. It says shipping within a week and I would expect about 4-5 days after that if you did not get express shipping.

I have been reading through the forum and it looks like I will be able to get all the help I need here.

I live in Santaquin Utah. Small little town but its quiet. =)

Hi all. I just ordered my Max V2. Now comes the waiting for it to ship, the actual shipping, then the assembly. I cant wait to get it started.