Search found 5 matches
- Mon Aug 02, 2021 10:17 am
- Forum: Rostock MAX v2
- Topic: Max v2 printer stopping mid print
- Replies: 1
- Views: 2648
Max v2 printer stopping mid print
I have had my Rostock Maxv2 for 6+ years. I have upgraded to an he280 hotend and ball joint arms/plastic carriages. I have the original rambo controller running repetier 0.92.2 and firmware date 20171204. I have had 2 failed prints in the past week (both on the same 24 hour print and both failed nea...
- Thu Jan 04, 2018 12:01 pm
- Forum: Rostock MAX v2
- Topic: Calibration Tower Probe Crash
- Replies: 1
- Views: 2491
Calibration Tower Probe Crash
When I run G29 to calibrate my max v2 with upgraded HE280 the probe works fine for the x and y towers but then crashes into the bed when it probes the z tower. I had this issue before with the x tower but it would go away after the calibration continued and the probe sensitivity was increased. Any i...
Re: White ABS
Well thanks for your input. Better late than never! I will have to try your settings and see if that further improves my results!
Re: White ABS
Thanks for the suggestions! I bumped the bed temp up to 95C and that did the trick. Forgot to mention that I was and still am using Kapton tape on the glass build plate.
White ABS
I built my Rostock Max v2 in December of 2014 and have been using the Blue ABS sold by SeeMeCNC ever since then. I decided to switch over to the white ABS also from SeeMeCNC and used the same settings as originally provided by SeeMeCNC in the instruction manual. These settings (228 nozzle 80 bed) wo...