Welcome to the SeeMeCNC Community

moving the bowden tube has solved the problem of the auto calibrate. thanks alot. takes bout 6 inches of tube free from the binder.

edit. nope that didn't work. completely removed the bowden as still having an issue.....

No the hot end is off

fixing the temp low end fixed that half... now when i run the auto level script it does x fine goes to z and does first tap hard and second slams into the bed and keeps going. never stops. sometimes power cycling it and keeping the script running works but that is about 1 in 10 tries. when it goes t...

flipping the hot end thermresistor helped the boot cycle but still giving the def issue

ok isolated boot issue to something in the i2c connection. problem is i don't have any loose wires and re-terminated the connection just to be certain. resistance across all soldered wires is .08 ohms the hotend main power wire is .04 ohms.

As far as I can tell I did wire it correctly but the current instructions do leave a lot to be desired

installed new cheapskates and hotend with the premade whip and now i can upload the new firmware and if i don't plug in the hotend the system will fully load if i plug in the hotend it gives me nothing but stays at the first splash screen. at first when the hotend was unpluged i would get my thermre...

Well that fixed it... now i feel like an idiot for not looking at that again.

Thank you very much for your help.

tried at both 190c and 200c and still did nothing forgot to mention i'm using the Mac client of mattercontrol will get out the multimeter again tommorow and recheck the continuity but i saw elsewhere that the instructions for rewiring the stepper my not have the right configuration. but that also me...

I tried searching and can't find anything about my particular issue so i shall ask. my stepper motor for my extruder does exactly nothing..... no twitch no dance has continuity and the XYZ motors work fine. it's plugged into the far right socket on the RAMBO. they are the kyo...whatever ones and i a...