ah ha! That all sounds pretty appealing!
Slice using MatterControl then load to the Rpi is different than just printing via MatterControl the usual way? Could you tell me what you mean on that?
Thank you for your help on this!
Search found 30 matches
- Wed Nov 23, 2016 1:51 am
- Forum: RostockMAX v3
- Topic: Raspberry Pi benefits?
- Replies: 21
- Views: 13000
- Wed Nov 23, 2016 12:04 am
- Forum: RostockMAX v3
- Topic: Raspberry Pi benefits?
- Replies: 21
- Views: 13000
Raspberry Pi benefits?
I tried to figure this out by browsing a few threads but just didnt get what I was looking for so heres my questions: If I upgrade to a v3 (I have a v2), what are the benefits of the raspberry pi option? Just that you can connect via network or wifi? Or does it mean you can print, and not worry abou...
- Thu Jun 30, 2016 12:40 am
- Forum: MatterControl
- Topic: numbers on the bed in MC
- Replies: 2
- Views: 3757
numbers on the bed in MC
When you view a print in matter control and you see it there spinning in 3d or 2d in a preview, what are the numbers next to each circle?
Centimeters radius?
And assuming that they are centimeters, can you switch to inches?
Centimeters radius?
And assuming that they are centimeters, can you switch to inches?
- Sat Jun 13, 2015 2:39 am
- Forum: Troubleshooting
- Topic: What causes the nozzle to simply stop moving?
- Replies: 15
- Views: 8231
Re: What causes the nozzle to simply stop moving?
so do you have to print from the sd card in order to prevent that from happening, and without the usb plugged in? What good is MatterControl if you cant continue a print after your comp falls asleep?
- Mon Jun 08, 2015 6:31 pm
- Forum: Members Marketplace
- Topic: Parts From Warner Berry (BerryBot Maker) Now Available
- Replies: 3
- Views: 4851
Re: Parts From Warner Berry (BerryBot Maker) Now Available
Would using the magnetic joints, the rods, and effector platform they sell cause the need to change the firmware for a Rostock Max V2? or would you just recalibrate and thats it?