Search found 31 matches

by Falk3r
Sat Dec 19, 2015 5:17 pm
Forum: Troubleshooting
Topic: Change EEPROM Settings? (PID Autotune Overshoot) [Solved]
Replies: 6
Views: 4933

Re: Change EEPROM Settings? (PID Autotune Overshoot)

Well, the Bed Autotune continues to timeout, but I've pressed on with a plan to circle back around later. I was able to iteratively calibrate the Z-Height and the individual tower height settings. Now I'm stuck on the Extruder Stepper Operation; I don't see the Extruder Temperature Override "PL...
by Falk3r
Sat Dec 19, 2015 4:23 pm
Forum: Troubleshooting
Topic: Change EEPROM Settings? (PID Autotune Overshoot) [Solved]
Replies: 6
Views: 4933

Re: Change EEPROM Settings? (PID Autotune Overshoot)

Got one set of results before an Autotune timeout.

Entered those as updated Bed PID values; rerunning.
by Falk3r
Sat Dec 19, 2015 3:51 pm
Forum: Troubleshooting
Topic: Change EEPROM Settings? (PID Autotune Overshoot) [Solved]
Replies: 6
Views: 4933

Re: Change EEPROM Settings? (PID Autotune Overshoot)

To continue complete documentation of my saga; this lower max value enabled my Autotune to complete 2 of 3 attempts. I averaged the P, I, and D values and updated the EEPROM with those while also upping the PID max value to 150 from 128. With these values, the Autotune completed fully, and I re-upda...
by Falk3r
Sat Dec 19, 2015 3:22 pm
Forum: Troubleshooting
Topic: Change EEPROM Settings? (PID Autotune Overshoot) [Solved]
Replies: 6
Views: 4933

Re: Change EEPROM Settings? (PID Autotune Overshoot)

OK, I think I'm getting closer. Options tab in MatterControl 1.4, EEProm Settings -> CONFIGURE button.

Extr.1 PID max value [0-255] was 255, now is 128.

Retesting...
by Falk3r
Sat Dec 19, 2015 3:19 pm
Forum: Troubleshooting
Topic: Change EEPROM Settings? (PID Autotune Overshoot) [Solved]
Replies: 6
Views: 4933

Change EEPROM Settings? (PID Autotune Overshoot) [Solved]

M303 S200 <-Error:PID Autotune failed! Temperature to high This is my initial PID calibration, so I have no fan blowing on the hot end yet. There was a little bit of smoke; it seemed the RTV was baking out some particles, hard to say if it was more or less smoke than the manual told me to expect. No...
by Falk3r
Mon Dec 07, 2015 4:50 pm
Forum: SeeMeCNC crew in the wild
Topic: World Maker Faire NY 2015 Sept. 26-27
Replies: 2
Views: 5665

Re: World Maker Faire NY 2015 Sept. 26-27

Can you share what was shown? I heard something about a RoMax v3 prototype? What was updated from the v2?

Go to advanced search