Welcome to the SeeMeCNC Community

How can i make this fan not have such a high pitched whistle sound to it? its driving me crazy!

it didn't it was running all night after the print finished.

Okay so after a print finishes and the tower goes to home the fan still runs and makes this annoying whining noise how can i make it so the fan shuts off when the print is done?

Tincho85 wrote:Fix this tower. It looks that there it's printing a bit away from z=0

Untitled-2.jpg

i do that by running the tower script and adjusting the screw right?

How did your first two prints in ABS go? the PEEK fan housing and the layer fan housing? did you prep the plate with purple elders glue as per the manual first? since you should not try PLA until you have those ABS fans installed and working I assume you did that is the nozzel clean and did you pur...

When it does start printing it's late after the first few things haven't stuck and it does this

I had no issues printing the test print cube but now when i attempt to print something bigger it doesnt stick to the bed, the PLA filament just clumps up at the end of the extruder