Welcome to the SeeMeCNC Community

Thanks will look on github

I had my company buy the droplit printer. It sat on a shelf for over one year before I was asked to help them out. I have the printer together and projector all set.
I am unable to find the firmware needed and with CW I am unable to locate setting.

Any help would be great.

mike

i want to change the extruder out for a dual/ with a 2 to 1 gear ratio what setting do i need to change?
this is for the Max.

I there is something posted about this im sorry i was not able to find it.

Max just up about 6 inches as it starts to print. the firm ware is the latest one for the MAX.
any ideas would be great on this.
hope i can get help

Sorry about no being clear..yes i load the test cube, then i feed the filament into the tube. use the up arrow on the Repetier-Host and it feeds though and starts to come out like the pdf states. after doing that i now click on print and its at that point the filament backs up. im using Repetier-Hos...

thank for the help was able to program and get that part working...have a question about the test print from the pdf...I am got the cube file and put the settings in the slic3r and feed filament though the hot end and this worked but now went i goto print the job the filament run back up in the tube...

thank you for the info...sorry to ask but what do i use to do this....I have the printer connected via usb cable. how can i read the firmware to make the changes.
thanks

I have read a lot of things on the forum and it get very confusing. thank you for help in advance I get about 1 inch away from the heated bed and it will not go down any more. I have read the pdf and i dont understand where to go and change the default by 10 for the Rostock MAX is 345.0 I have heate...